Traps wrongly processed
| There are scenarios in which two trap OIDs from the same vendor are almost similar. Example .1.3.6.1.4.1.6431.1.1.1.1515 .1.3.6.1.4.1.6431.1.1.1.15 Though the user have created separate trap processors for each trap OID, an incoming trap with a trap OID .1.3.6.1.4.1.6431.1.1.1.1515 can be processed by a different trap processor meant for .1.3.6.1.4.1.6431.1.1.1.15. This is because trap processor's trap OID is present inside the in coming trap message. In order to avoid this, the trap OIDs should be wrapped by < and > symbols. ie Edit the Admin-->SNMP trap processor meant for .1.3.6.1.4.1.6431.1.1.1.1515 and wrap the trap OID like <.1.3.6.1.4.1.6431.1.1.1.1515> Save the trap processor. Traps will be processed by the correct processors. |
New to ADSelfService Plus?
Related Articles
Traps not received in OpManager
Please check below for the possible reasons for not receiving the traps and its corresponding resolution. 1. Trap port might be occupied in opmanager server. ---> Make sure the that trap port of OpManager is not occupied by trap service of Operating ...REMOVING UNSOLICITED TRAPS FROM OPMANAGER DATABASE
Connect to OpManager database and execute the below query : Refer the link below to connect to OpManager database : https://support.zoho.com/portal/manageengine/helpcenter/articles/connecting-to-the-opmanager-database 1. Run this command from the ...Difference between SNMP monitors and Traps
S.No SNMP Monitors Traps 1 Pull Model: OpManager sends SNMP request to the SNMP agent running on the monitored device and receives the response. Push Model: Monitored device(SNMP agent) sends messages in the form of traps to the trap ...Adding Trap processors by loading vendor trap Mibs in OpManager
Question : How do I add Trap processors by loading vendor Trap Mibs in OpManager? Solution: To add trap processors, copy the vendor trap mibs to Opmanager\mibs folder and go to Admin-> SNMP Trap Processors> mouse over Actions tab and click on Load ...How to configure trap message?
Trap Protocol Data Unit Information and Varbinds Important: To specify Trap PDU information for Trap Parser fields, use the dollar ($) notation. For Event Parsers and Event Filters, use percentage (%) notation instead of dollar ($). The @ notation ...