Installing and Creating Bootable FuzeDrive When More Than 2 Drives are installed on your system

Installing and Creating Bootable FuzeDrive When More Than 2 Drives are installed on your system

Installing and Creating Bootable FuzeDrive When More Than 2 Drives are installed on your system

 

  1. Be sure to always back up any important data before installing.

  2. If using an SSD larger than the license amount (128GB or 1TB) as the boot drive, use disk imaging or cloning software (ex Macrium Reflect) to clone your boot drive to your HDD.

  3. Turn off the system and remove all drives except the boot drive from the system.

    1. Move boot drive to port 0 or port 1 on motherboard

  4. Boot the system and install the FuzeDrive software, rebooting the system when prompted.

  5. Once the system has booted, shutdown the system and plug a blank drive that you wish to add to your boot drive.

    1. If the other drive has data, transfer the data to another drive.

      1. Once the data has been transferred, remove the drive where the data was moved to from the system and clean the drive that will be added to the boot drive.

  6. Launch FuzeDrive

    1. If booting from an SSD select expand my boot drive and follow the on screen instructions and reboot when prompted.

    2. If booting from a HDD select the accelerate my boot drive option and follow the on screen instructions and reboot when prompted.

  7. After the system has rebooted, shutdown the system and add the rest of your drives back into the system.

  8. Start up the system and the process should be complete.


    • Related Articles

    • Deleting FuzeDrive and VirtualSSDs

      Important: The following steps deletes the FuzeDrive and ALL DATA that is stored on each of the drives. All data is completely lost on the FuzeDrive and/or underlying drives so only use this option under the following circumstances. (a) you have ...

    • Uninstalling FuzeDrive

      Background Once a disk has been converted to a FuzeDrive, the data begins to be distributed across the two different tiered storage devices. Depending how long you have been using the FuzeDrive, the data may be widely distributed (as is typical in a ...

    • System Requirements For FuzeDrive

      Is my system compatible with Enmotus FuzeDrive™? FuzeDrive installation is simple and only takes about 5 minutes.  Remember, always back up your data prior to installation of any new software.  FuzeDrive requires Windows 10, and is compatible with ...

    • Cleaning Drives Using Diskpart

      When trying to create a data FuzeDrive preserving data and the error message "For transform data, only one drive may have a partition" appears, this means you need to clean one of your drives. IMPORTANT: The following steps will completely erase all ...

    • Failure to Boot or "Inaccessible Boot Device" after Creating a Bootable FuzeDrive - EFI Recovery

      This article only applies to FuzeDrives that have never booted successfully.  See this article for a FuzeDrive that booted at least once successfully, but no longer does. For an ACPI BIOS ERROR blue screen (we've so far only seen this with ASUS ...