Probe bluetooth connection

Probe bluetooth connection

Sometimes the probe will not connect, this is usually because the batteries need to be above a certain threshold for the bluetooth to kick in
Either connect your CleanGrow auxiliary battery pack or recharge your probe for a bit

    • Related Articles

    • Disconnecting from Bluetooth

      Check that the batteries are charged in the probe. If they haven't been charged or the probe used in a while that might be the issue. Some users report that on first use they have to also go to the bluetooth settings of their phone and connect with ...

    • Charging the probe

      To charge the probe, use the cable supplied via a computer USB port, or a standard phone charger. Charging is controlled to preserve the longevity of the battery so takes a few hours to ideally over night. You can see the charge level of the battery ...

    • Bluetooth not connecting straight away on Android

      We are aware that on some android devices the probe does not connect straight away, i.e you press the reconnect, a menu appears, you press the probe and press connect, yet nothing happens, the LED stays blinking red. Just go ahead and try again and ...

    • What probe type do I have

      Sensor Combinations M62 [Ca2+, Cl-, K+, Na+, NH4+, NO3-] M63 [Ca2+, Cl-, Mg2+, Na+, NH4+, NO3-] M64 [Ca2+, Cl-, K+, Mg2+, NH4+, NO3-] M67 [Ca2+, Mg2+, K+, Na+, NH4+, NO3-] M68 [Ca2+, Cl-, K+, Na+, Mg2+, NO3-] ​NPK2 [Ca2+, K+, Mg2+, NH4+, NO3-, PO43- ...

    • Can I put the probe directly in soil?

      No, Ion Selective electrodes can only work in liquid, they are potentiometric and work by measuring the potential difference between the charge built up as a result of free ions in solution against the fixed potential of the reference electrode also ...